Melting & Holding Furnaces
AMT 600AI/B
- For holding the molten metal in temperature, only 30-50% total power will be consumed.
- In the Chart, the maximum capacity of crucibles has been mentioned.
The real capacity is 10% less than the nominal capacity of the crucible.
AMB 600 Al
Bale-out Furnaces
- For holding the molten metal in temperature, only 30-50% total power will be consumed.
- In the Chart, the maximum capacity of crucibles has been mentioned.
The real capacity is 10% less than the nominal capacity of the crucible.
- In the Chart, the maximum capacity of crucibles has been mentioned.
The real capacity is 10% less than the nominal capacity of the crucible.
AMT 600 /Al AMB 150/CU AMB 300/AL
Applications:
• Melting and holding of non-ferrous metal
• Melting and holding of non-ferrous metal
(Al Alloys & Cu Alloys)
Specifications:
• Heating from all sides
• Heating elements on ceramic tubes
• Emergency exit for molten metal
• Electronic control system with thyristor
• Heating from all sides
• Heating elements on ceramic tubes
• Emergency exit for molten metal
• Electronic control system with thyristor
• Two models: - Bale out
- Tilting
• Excellent heat insulation for maximum energy saving
- Tilting
• Excellent heat insulation for maximum energy saving
Crucible:
• Graphite or SiC crucible
• With spout and without spout
• With spout and without spout
AMT 420 AL/B AMB 50/CU AMT 350 Al/B
. Location of the thermocouple and the temperature measurement could be in one of the
following methods:
. Thermocouple installed at the internal furnace wall, measuring the temperature at the
rear of the crucible
. Thermocouple installed inside the crucible wall (applicable just for stationary furnaces)
. Thermocouple installed inside the molten metal by means of special ceramic tubes
. Easy maintenance & repairing of the lining by means of new isolation techniques
. Optional ventilation system to remove process vapors and gases
following methods:
. Thermocouple installed at the internal furnace wall, measuring the temperature at the
rear of the crucible
. Thermocouple installed inside the crucible wall (applicable just for stationary furnaces)
. Thermocouple installed inside the molten metal by means of special ceramic tubes
. Easy maintenance & repairing of the lining by means of new isolation techniques
. Optional ventilation system to remove process vapors and gases
